1. Home
  2. Docs
  3. Nodes
  4. Control Lines
  5. LFO Node

LFO Node

Low-frequency oscillator, used to automate the parameters of other Nodes.


Frequency-control A Control input to automate the Frequency setting, in Hz, from 0+ Hz to the Nyquist frequency. This input can be toggled from the Node settings panel.


Frequency Sets the oscillator frequency, in Hz.
Phase shift Sets oscillator initial phase shift, in full periods. Maximum value is 1, which means a whole period.
Output value mix. Minimum value of the periodic wave/function.
Max value. Maximum value of the periodic wave/function.
Wave type Sets the oscillator’s wave type (sine, sawtooth, square, triangle, etc.).
Always on When set, the LFO runs continuously, instead of starting on playback.


Control LFO value.
Was this article helpful to you? Yes No